Editing MIDI note parameters in piano roll using Sylenth
Return to “FL Studio Users Forum (Looptalk)”
Forum rules
Please read them here.
Please read them here.
[You can only see part of this thread as you are not logged in to the forums]
Editing MIDI note parameters in piano roll using Sylenth
Does anyone have a problem changing the midi note parameters such as velocity, pan etc in piano roll when using Sylenth? It doesn't work basically. Hoping there is a solution?
Re: Editing MIDI note parameters in piano roll using Sylenth
Velocity should normally work. But make sure it...
Re: Editing MIDI note parameters in piano roll using Sylenth
Thanks Nucleon, do you know how I map the param...
Re: Editing MIDI note parameters in piano roll using Sylenth
Check the right side of the mod controls, there...
Re: Editing MIDI note parameters in piano roll using Sylenth
Sorry not sure where and what you are referring...
Re: Editing MIDI note parameters in piano roll using Sylenth
aqf157 wrote:Sorry not sure where and what you ...
You do not have the required permissions to view the files attached to this post.
Re: Editing MIDI note parameters in piano roll using Sylenth
Thanks, I tried it and no difference :/ I must ...
Re: Editing MIDI note parameters in piano roll using Sylenth
Did you turn the knob next to it fully clockwis...
Re: Editing MIDI note parameters in piano roll using Sylenth
No I didn't, but I just tried again and still t...
Re: Editing MIDI note parameters in piano roll using Sylenth
aqf157 wrote:No I didn't, but I just tried agai...
Re: Editing MIDI note parameters in piano roll using Sylenth
Fair enough, at least you pointed me in the rig...
Re: Editing MIDI note parameters in piano roll using Sylenth
I have noticed that the velocity effects from t...
Re: Editing MIDI note parameters in piano roll using Sylenth
Sylenth does have a built in compressor effect....
Re: Editing MIDI note parameters in piano roll using Sylenth
Sorry to resurrect an old thread, but I've been...
You do not have the required permissions to view the files attached to this post.