In recent work with the LFO section of peak controller, I have noticed that the different waveforms have different offsets from "0." The offset is also highly rate dependant.
Is this something which could be enhanced at some point, or is it a technical thing which has no solution in the software realm?
Just for an example, turn up the "Vol" setting, without touching any other controls in peak controller. Then switch between triangle and ramp waveforms. Right away, you will notice that the triangle is centered above the zero point, while the ramp is offset completely below the zero point. Then start adjusting the rate, and you will notice that this offset and the differences change drastically based on the rate.
It seems like there needs to be some sort of "DC Offset" removal on the output of peak controllers LFO, or at least an option for it.
Simply seemed like a good topic, and possibly a way forward for this awesome internal controller!
Offset of LFO waveforms in peak controller
Return to “FL Studio Users Forum (Looptalk)”
Forum rules
Please read them here.
Please read them here.
[You can only see part of this thread as you are not logged in to the forums]
Re: Offset of LFO waveforms in peak controller
The shapes are synced to your song grid. You ca...
Re: Offset of LFO waveforms in peak controller
nucleon wrote:The shapes are synced to your son...
Re: Offset of LFO waveforms in peak controller
If you meant the way the shapes seem offset at ...
Re: Offset of LFO waveforms in peak controller
There must have been an honest to gosh glitch g...
Re: Offset of LFO waveforms in peak controller
No worries. Let us know if it happens again.