Hi everyone! As the title.
I thought about Stereo Shaper, but its phase knob doesn't do what i thought. Is there a way to set it up so you can move the phase without touching the stereo image?
I'm aware of other third party plugins but I was curious if it is possible only with FL plugins.
Thanks for your help
Phase alignment with FL stock plugins, possible?
Return to “FL Studio Users Forum (Looptalk)”
Forum rules
Please read them here.
Please read them here.
[You can only see part of this thread as you are not logged in to the forums]
Re: Phase alignment with FL stock plugins, possible?
Are you trying to phase align a single stereo t...
Re: Phase alignment with FL stock plugins, possible?
Thanks for your reply.
The second you said. I n...
Re: Phase alignment with FL stock plugins, possible?
I know that voxengo has some delay plugin you c...
Re: Phase alignment with FL stock plugins, possible?
Madma wrote:Nice idea the manual PDC, but prett...
Re: Phase alignment with FL stock plugins, possible?
Madma wrote:Thanks for your reply.
The second y...
Re: Phase alignment with FL stock plugins, possible?
I think you can also add latency offset using F...
You do not have the required permissions to view the files attached to this post.
Re: Phase alignment with FL stock plugins, possible?
A little off topic, but not entirely unrelated....
Re: Phase alignment with FL stock plugins, possible?
Thank you all for your suggestions.
I'll defin...
Re: Phase alignment with FL stock plugins, possible?
TheDichotomist wrote: ↑Sat Sep 23, 2017 5:10 pm...
Re: Phase alignment with FL stock plugins, possible?
Spivkurl wrote: ↑Fri Sep 22, 2017 11:28 am
Are ...
-
- Site Admin
- Thu Jun 25, 2020 1:27 am
Re: Phase alignment with FL stock plugins, possible?
thatveca wrote: ↑Thu Jun 25, 2020 1:13 am
What ...
Re: Phase alignment with FL stock plugins, possible?
You could also try an all pass filter in Love P...
You do not have the required permissions to view the files attached to this post.
Re: Phase alignment with FL stock plugins, possible?
Madma wrote: ↑Fri Sep 22, 2017 11:56 am
Nice id...