Operator panning articulation overridden by filter

find/exchange/discuss Sytrus presets & tips here

Return to “Sytrus - Presets & Programming”

[You can only see part of this thread as you are not logged in to the forums]
VimDoozy
Wed Jan 10, 2018 8:27 pm

x

Operator panning articulation overridden by filter

I noticed that articulations applied to the pan target for each operator are ignored when the operator is fed through a filter output. The articulations need to be set up on the filter itself it seems. Perhaps someone could explain why that is.

I was attempting to create a supersaw with custom panning via unison mapping, but when I feed these operators into one filter, since the panning articulation for each operator is ignored I must set it up within the filter itself - and now one unison map applies to all operators, whereas previously I had a unison map per operator.

Maybe someone can comment on that. Thanks.

Return to “Sytrus - Presets & Programming”