Automating Waveshape?
Return to “Sytrus - Presets & Programming”
[You can only see part of this thread as you are not logged in to the forums]
Automating Waveshape?
I'm working on a transition section from these nice atmospheric sine wave chords towards something a bit heavier. Playing in the synth, I think the best way to do it is slowly transition from the current sine wave to a sawtooth. Is there a way to automate this with this, or would I need to somehow automate the pattern outside the synth?
Re: Automating Waveshape?
Try assigning the volume articulator (VOL) of y...
Last edited by Zephyrean on Sun Jun 25, 2023 7:44 pm, edited 2 times in total.
Re: Automating Waveshape?
topher95 wrote: ↑Sat Jun 24, 2023 3:30 pm
I'm w...