AKAI MPC

MIDI Controllers FL Studio & Deckadance officially support
[You can only see part of this thread as you are not logged in to the forums]
Scott
Site Admin
Jun 11, 2009 (8:46)
The following page discusses slaving all MPC models to FL Studio.

mpc_fruityloops.png
mpc_fruityloops.png (68.85 KiB) Viewed 11665 times

http://www.akaipro.com/syncfruity

Note: FL Studio outputs Sync. It does not receive Sync.

Connect a MIDI cable from an available MIDI OUT of your MIDI interface to an available MIDI IN on your MPC.

Using MIDI Time Code (MTC) & MIDI Machine Control (MMC):

On MPC5000 / 2500:

1. Go to the MIDI/Sync menu.
2. Set "Sync In" to the corresponding MIDI input port on the MPC.
3. Set "Mode" to "MIDI Time Code."
4. Set the Tempo of the MPC sequence to match that of your FL Studio session.

In FL Studio:

1. Go to the Options Menu > MIDI Settings or press F10 on your keyboard.
2. Under the Output section, choose the device port of your MIDI interface to which you have connected the MIDI cable to the MIDI IN on your MPC.
3. Enable "Send Master Sync."
4. Select the Synchronization Type "MTC 30 fps."
5. Close the Preferences window.
6. Press Play. Your MPC will now play in-sync with FL Studio.

Using MIDI Beat Clock & MIDI Machine Control (MMC):

On MPC5000 / 2500:

1. Go to the MIDI/Sync menu.
2. Set "Sync In" to the corresponding MIDI input port on the MPC.
3. Set "Mode" to "MIDI Clock."
4. Set "Receive MMC" to "ON."

On the MPC500:

1. Go to the MIDI/Sync menu.
2. Press Mode + PAD 7.
3. Turn the data wheel to display "Sync."
4. Press the DOWN cursor.
5. Use the data wheel to change the sync mode to "Slave."

On the MPC1000:

1. Go to the MIDI/Sync Menu:
2. Press Mode + PAD 9.
3. Sync [F2].
4. Sync In: 1 or 2 (whichever MIDI input you plugged your MIDI cable into).
5. Sync Out: Off.

In FL Studio:

1. Go to the Options Menu > MIDI Settings or press F10 on your keyboard.
2. Under the Output section, choose the device port of your MIDI interface to which you have connected the MIDI cable to the MIDI IN on your MPC.
3. Enable "Send Master Sync."
4. Select the Synchronization Type "MIDI Clock."
5. Close the Preferences window.
6. Press Play. Your MPC will now play in-sync with FL Studio.

All trademarks and registered trademarks are the property of their respective owners.
What's this knob do? The F1 key is your friend!

Click here for (Advanced Forum Search)