Korg nanoKONTROL/nanoKONTROL2

MIDI Controllers FL Studio & Deckadance officially support
[You can only see part of this thread as you are not logged in to the forums]
nucleon
 
Apr 25, 2012 (16:35)
Manufacturer: Korg

Supported since: FL 10.6 Beta

Transport buttons supported. No special automatic mapping for knobs, faders and other buttons. Manually link them to parameters in FL Studio.

nanoKONTROL2 setup:

1. Download and install the Korg Kontrol Editor from the Korg website and open the mapping file designed for FL located in:
FL Studio\System\Hardware specific\Korg nanoKONTROL2\FL Studio - nanoKONTROL2.nktrl2_data

2. Transmit the mapping file to the device.

3. Load FL Studio and enable the Korg nanoKONTROL2 entry in MIDI input options and set it as the 'Korg nanoKONTROL2' controller type.

4. Optional: Set the same port number for its input and output entries if you require LED feedback of the play, record and cycle buttons.

Transport buttons control play, stop, record and the cycle button toggles between song and pattern mode.

KORG nanoKONTROL 2.jpg
KORG nanoKONTROL 2.jpg (39.93 KiB) Viewed 10363 times


nanoKONTROL setup:

1. Download and install the Korg Kontrol Editor from the Korg website and open the mapping file designed for FL located in:
FL Studio\System\Hardware specific\Korg nanoKONTROL\FL Studio - nanoKONTROL.nktrl_set

2. Transmit the mapping file to the device.

3. Load FL Studio and enable the Korg nanoKONTROL entry in MIDI input options and set it as the 'Korg nanoKONTROL' controller type.

Transport buttons control play, stop, record and the cycle button toggles between song and pattern mode.

KORG nanoKONTROL 1.jpg
KORG nanoKONTROL 1.jpg (43.84 KiB) Viewed 9889 times