Korg nanoPAD/nanoPAD2

MIDI Controllers FL Studio & Deckadance officially support
[You can only see part of this thread as you are not logged in to the forums]
nucleon
 
Aug 16, 2012 (11:31)
Manufacturer: Korg

Supported since: FL 10.6 Beta

Korg nanoPAD and nanoPAD2 work as generic drum pad controllers by default, but you can also use preset mappings for triggering clips in Performance mode and link the XY pad to two parameters.

nanoPAD2 Performance mode setup:

1. Download and install the Korg Kontrol Editor from the Korg website and open the mapping file designed for FL located in:
FL Studio\System\Hardware specific\Korg nanoPAD2\Performance mode.nanopad2_set

2. Transmit the mapping file to the device.

3. Load FL Studio and enable the Korg nanoPAD2 entry in MIDI input options and set it as the 'Korg nanoPAD' controller type.

4. Link parameters to MIDI CC 1 and CC 2 to control them from the X and Y positions on the XY pad.

Pads trigger clips in Performance mode. Change scene to access more clips.

KORG nanoPAD 1.jpg
KORG nanoPAD 1.jpg (53.09 KiB) Viewed 7154 times


nanoPAD Performance mode setup:

1. Download and install the Korg Kontrol Editor from the Korg website and open the mapping file designed for FL located in:
FL Studio\System\Hardware specific\Korg nanoPAD\Performance mode.nanopad_set (vertical layout) or:
FL Studio\System\Hardware specific\Korg nanoPAD\Performance mode (alt).nanopad_set (horizontal layout)

2. Transmit the mapping file to the device.

3. Load FL Studio and enable the Korg nanoPAD entry in MIDI input options and set it as the 'Korg nanoPAD' controller type.

4. Link parameters to MIDI CC 1 and CC 2 to control them from the X and Y positions on the XY pad.

Pads trigger clips in Performance mode. Change scene to access more clips.

KORG nanoPAD 2.jpg
KORG nanoPAD 2.jpg (20.39 KiB) Viewed 7154 times