Hi,
i synced my Volca Beats with FL-Studio. When i press the FL-Play-Button, the Volca plays, no problem so far. But how to send FL-Sequenzer-Data to the Volca? I do not understand the MIDI-Chart of the Volca Beats. Why there are no #XXs? I can get out Sounds out of a Hardwaresynth via MIDI-Out; i think there is something similiar, but i cant find it.
BTW... How to turn off the "LIVE"-Mode; its always on and i cant find any Information about this Mode. The Factory-Reset wasnt a solution and i tried a lot of combos already : )
Thank you very much in advance for your answer ( : 3)
Korg Volca Beats - Softseq.-Data to HW
Return to “MIDI Controller Support”
[You can only see part of this thread as you are not logged in to the forums]
Korg Volca Beats - Softseq.-Data to HW
You do not have the required permissions to view the files attached to this post.
Re: Korg Volca Beats - Softseq.-Data to HW
in the midi settings panel, where you enabled m...
Re: Korg Volca Beats - Softseq.-Data to HW
Thank you, it works fine now.
Re: Korg Volca Beats - Softseq.-Data to HW
I have the same problem and didn't found any so...
Re: Korg Volca Beats - Softseq.-Data to HW
SanSedana wrote:I have the same problem and did...