Hello,
I try to run the new Beatstep Pro as slave with FL12.
Arturia tried to help me but after all they said Image line should say something to it:
+++++++++++++++++++++++++++++++++++++++++++++++++
Hello ,
Unfortunatelly, FL-Studio is using specific MIDI protocols, for more informations, the best is to send them an email.
Sorry for not been able to help you more on that subject.
Regards,
David
--
Distributors
distributors.support@arturia.com
---------------------------------------------------------------------------
Arturia Distributors Support
Visit: http://arturia.com/support/faq/
-----------------------------------------------------------------------------
>Hello David,
>
>I tried your configuration with no success.
>
>I need to set the input tab also so that FL Studio starts if I press play on
>the BSP.
>
>If I set the sync on the BSP on USB the BSP does nothing.
>
>This the config that enables the BPS to start with the start knob.
>
>By the way, is the a secret option to use the drum sequencer as melody
>sequencer, means that I have 3 sequencers for melody? I would prefer to use
>the SparkLE drums controller for the drums section instead of the BSP.
>
>Thanks
>
>Chris
>
------------------------------------------------------------------------------------------
>
>Hello,
>
>If you use press the SYNC button until you see the USB lit.
>
>Then configure FL-Studio, you will be able to press play on your FL-Studio
>and it will send the transport message to BSP.
>
>Thanks
>
>David
>
>--
>Distributors
>distributors.support@arturia.com
>---------------------------------------------------------------------------
>Arturia Distributors Support
>
Beatstep Pro as MIDI Slave doesn't work
Return to “MIDI Controller Support”
[You can only see part of this thread as you are not logged in to the forums]
Re: Beatstep Pro as MIDI Slave doesn't work
Do you have the device in Control Mode in order...
Re: Beatstep Pro as MIDI Slave doesn't work
This is the setting:
The Beatstep Pro is in U...
Re: Beatstep Pro as MIDI Slave doesn't work
Do you have "Enable MIDI Master Sync" selected ...
Re: Beatstep Pro as MIDI Slave doesn't work
Yes, this option is enabled.
Re: Beatstep Pro as MIDI Slave doesn't work
It's displaying as not synced in your MIDI Sett...
Re: Beatstep Pro as MIDI Slave doesn't work
Good advice.
The BSP does work now and take ove...
Re: Beatstep Pro as MIDI Slave doesn't work
In MIDI Control Center check if your Transport ...
Re: Beatstep Pro as MIDI Slave doesn't work
I found only MCU or HUI in Midi Control center....
Re: Beatstep Pro as MIDI Slave doesn't work
I tried MMC but didn't help.
Re: Beatstep Pro as MIDI Slave doesn't work
I now tried MIDI but didn't help.
I still need ...
Re: Beatstep Pro as MIDI Slave doesn't work
I'm not completely sure why that's occurring as...
Re: Beatstep Pro as MIDI Slave doesn't work
If I enable "MIDIIN2 (Arturia BeatStep Pro)" th...
Re: Beatstep Pro as MIDI Slave doesn't work
Have you tried setting MIDIIN2 to the same Port...
Re: Beatstep Pro as MIDI Slave doesn't work
Hi! I'm curious if beatstep works with patterns...
Re: Beatstep Pro as MIDI Slave doesn't work
Do you have a MIDI feedback loop? that will cer...