Midi Routing and DIN Sync

Discuss MIDI Controller support/issues here

Return to “MIDI Controller Support”

[You can only see part of this thread as you are not logged in to the forums]
DamienAcid303
Tue Apr 25, 2017 6:12 am

x

Midi Routing and DIN Sync

So, recently picked up a SQ1 from Guitar Center for my System1M Semi Modular. Also picked up a Korg Electribe 2, I was curious if what I could do was take the MIDI signal from my MX1 that's clocking the Korg Electribe. From there, I would DIN Sync out to the SQ1 to clock that and sequence the System 1M. The SQ1's CV and Gate out seem to be bad as I can't trigger anything, so the Sequence is being done via MIDI out from the SQ1. Attached is a quick design of what exactly I'm trying to make work.

My ultimate goal is to use the Korg Electribe, to sync the sequence of the system 1M by DIN syncing from it, so I can have everything clocked in at once. The issue is when I plug in DIN sync, it seems to over take midi and stops the ability to trigger everything from FL or from the MX1
You do not have the required permissions to view the files attached to this post.

nucleon
Thu Apr 27, 2017 9:46 am

x

Re: Midi Routing and DIN Sync

I use this to send MIDI Sync from FL to 3 Korg ...


Return to “MIDI Controller Support”