Determining CC or NRPN values for hardware synth controls

Discuss MIDI Controller support/issues here

Return to “MIDI Controller Support”

[You can only see part of this thread as you are not logged in to the forums]
josh303
Sat May 08, 2010 8:37 pm

x

Determining CC or NRPN values for hardware synth controls

Hi all, I'm Josh. I just got FL Studio to use as a master sequencer for my MIDI hardware synths, drum machines, etc.

Programming note on/off and velocity data has been no problem and has made sequencing much, much easier. However, how would I determine which CC or NRPN to use to control a particular hardware device parameter? The manual mentioned moving a given control and looking under the Debug log to see which CC or NRPN value the knob corresponds to. I did this, and the Debug log recorded the knob tweak, but I cannot understand its esoteric language. I was hoping it would display something simple like "CC #092, value: 127", but the readout is very complex and not intuitively obvious as to how to decipher it.

Thanks for your help,
-Josh

Return to “MIDI Controller Support”