Dahsboard Rename doesn't show in step sequencer
Return to “Technical Support (Windows)”
Forum rules
TECHNICAL SUPPORT HAS MOVED!
Technical support has moved to ticketing - START HERE
Some self-help links ...
NOTE: Technical Support is ONLY available Monday - Friday (9 am to 5 pm), it can take a few days to get a response depending on the level of demand. Thank you for your patience.
TECHNICAL SUPPORT HAS MOVED!
Technical support has moved to ticketing - START HERE
Some self-help links ...
NOTE: Technical Support is ONLY available Monday - Friday (9 am to 5 pm), it can take a few days to get a response depending on the level of demand. Thank you for your patience.
[You can only see part of this thread as you are not logged in to the forums]
Dahsboard Rename doesn't show in step sequencer
Make a new project and add a dashboard to it. Now open the dashboard up, and right click its top handle area. Rename it in the popup window. Now look at the step sequencer. It isn't renamed there. Contrast that with the behavior of generators, such as sampler. Renaming a sampler from that container view results in the step sequencer showing the new name, as well. The containers should behave the same for both, in this regard.
Re: Dahsboard Rename doesn't show in step sequencer
It works here:
Slightly unrelated, but I not...
Re: Dahsboard Rename doesn't show in step sequencer
Scoox wrote:It works here:
Slightly unrelate...
Re: Dahsboard Rename doesn't show in step sequencer
Works here as well, 32bit and 64bit FL 12.1.3.
Re: Dahsboard Rename doesn't show in step sequencer
I recommend you install FL12, it has a lot of r...
Re: Dahsboard Rename doesn't show in step sequencer
Scoox wrote:I recommend you install FL12, it ha...
Re: Dahsboard Rename doesn't show in step sequencer
It's mostly a UI revamp but they've also added ...
Re: Dahsboard Rename doesn't show in step sequencer
Scoox wrote:It's mostly a UI revamp but they've...