Mid/Side EQ for Patcher (Effect)
Made this so you could actually see the Side signal in Parametric EQ whilst adjusting frequencies !
Suggested Uses:
1) Use on a Master Track to high pass everything in the Sides above a certain frequency, say 90 to 120 Hz, leaving Mono only below that frequency.
2) Enhance the high frequencies in the stereo field by scooping Mids out (using Mid EQ) and boosting Sides at the same frquency (using Side EQ) thereby widening stereo field at just that frequency range.
3) Use on an Insert Track to control stereo separation with custom frequency tailoring of a particular sound.
4) Experiment.
This set up is not the same as simply adjusting the stereo separation knob on FL's Mixer because that affects the full audio spectrum. This set up allows adjusting stereo separation on a frequency tailored basis similar to Fab Filter Pro Q EQ or one of iZotope Ozone's Equalizers set to Mid/Side mode. The challenge I found is that Fruity Parametric EQ does not display a pure "Side only" signal - it shows up blank. The work around, I found, was to invert the right channel's Side signal before and after the so called Side EQ in this Patcher set up, thus enabling you to "see" the "Side only" signal in Fruity Parametric EQ ... because Fruity Parametric EQ can easily show the mono version of that "Side only" signal. But to combine it back with the Mono signal correctly, the right channel of the Side signal needed to be inverted again.
Uses FL's native plugins.
It is important to leave the yellow noodle volume adjustment parameters at 100% or else you may color the output in some unwanted fashion.
Cheers .
Mid/Side EQ for Patcher
[You can only see part of this thread as you are not logged in to the forums]
Mid/Side EQ for Patcher
- Attachments
-
- Mid_Side EQ.jpg (88.84 KiB) Viewed 6014 times
-
- Mid_Side EQ.fst
- (10.16 KiB) Downloaded 1170 times
Last edited by richmaloon on Thu Oct 27, 2016 1:28 pm, edited 2 times in total.
Re: Mid/Side EQ for Patcher
Thank you very much. I didnt know this was poss...
Re: Mid/Side EQ for Patcher
There's a slightly easier way to achieve this: ...
- Attachments
-
- ms-eq.fst
- (7.73 KiB) Downloaded 798 times
Re: Mid/Side EQ for Patcher
Lummy,
An elegant implementation indeed.
Re: Mid/Side EQ for Patcher
Works perfectly in 2022. It is my first time us...
Re: Mid/Side EQ for Patcher
this is so good, was working on a master and th...