WARNING ADJUST VOLUME AS YOU GO SO IT DOESN'T CLIP OR BLOW OUT YOUR EAR DRUMS.
open up harmor turn both oscillator A and B on.
set oscillator B on a square wave.
set oscillator A on saw and set it on a unison of 2 and a unison pitch of 19%
now link bot oscillators together and select the Leg low pass envelope and set the frequency to 37%
go to the "FX" tab down at the bottom and set it to flat hat distortion.
now send it to a free mixer track and load the "Effector" FX Module make sure that "VOX" is high lighted and turn click the bypass button and set the X and Y Parameters to 0
and 1 extra optional step is to add a little but of porta mento
and of course eq to your liking.
I'd love to hear some feedback.
how to make a roll bass.
Return to “Harmor - Presets & Programming”
[You can only see part of this thread as you are not logged in to the forums]
how to make a roll bass.
Last edited by Agerix on Sat Feb 18, 2017 4:38 am, edited 2 times in total.
Re: how to make a roll bass.
here is what it should sound like.
You do not have the required permissions to view the files attached to this post.