Why when I link loop start/end to patcher knob ( or any other control ) I can not fine tune the knob?
Also why is there gap when I copy sample start and paste it to loop start?
Direct Wave fine automation not possible
Return to “Technical Support (Windows)”
Forum rules
TECHNICAL SUPPORT HAS MOVED!
Technical support has moved to ticketing - START HERE
Some self-help links ...
NOTE: Technical Support is ONLY available Monday - Friday (9 am to 5 pm), it can take a few days to get a response depending on the level of demand. Thank you for your patience.
TECHNICAL SUPPORT HAS MOVED!
Technical support has moved to ticketing - START HERE
Some self-help links ...
NOTE: Technical Support is ONLY available Monday - Friday (9 am to 5 pm), it can take a few days to get a response depending on the level of demand. Thank you for your patience.
[You can only see part of this thread as you are not logged in to the forums]
Direct Wave fine automation not possible
You do not have the required permissions to view the files attached to this post.
-
reflex
- Site Admin
- Wed Aug 28, 2013 7:50 am
Re: Direct Wave fine automation not possible
I don't know, but I'll check it out at some poi...
-
reflex
- Site Admin
- Wed Oct 30, 2013 3:51 pm
Re: Direct Wave fine automation not possible
I'm afraid it's because DW doesn't use enough r...