Hello,
Hopefully someone can help me!!! I have my Virus TI2 connected with USB. Everything works perfectly, except the 3 Audio Outputs! I have tried a lot in the meantime, but i didnt succeed.
After searching a lot on different forums, I found an article on this subject. There was said in FL Studio it is not longer possible to use the 3 Output Channels of the Virus TI2 and a change in the FL Studio software about Delay Compensation is the cause of this......
Can someone tell me something about this? Is there a fix for this problem???
Big thanks in advance!
Regards,
Jeroen
ACCESS VIRUS TI2 | 3 Audio Outputs
Return to “Technical Support (Windows)”
Forum rules
TECHNICAL SUPPORT HAS MOVED!
Technical support has moved to ticketing - START HERE
Some self-help links ...
NOTE: Technical Support is ONLY available Monday - Friday (9 am to 5 pm), it can take a few days to get a response depending on the level of demand. Thank you for your patience.
TECHNICAL SUPPORT HAS MOVED!
Technical support has moved to ticketing - START HERE
Some self-help links ...
NOTE: Technical Support is ONLY available Monday - Friday (9 am to 5 pm), it can take a few days to get a response depending on the level of demand. Thank you for your patience.
[You can only see part of this thread as you are not logged in to the forums]
Re: ACCESS VIRUS TI2 | 3 Audio Outputs
Fidelity Music, can you help me?
Re: ACCESS VIRUS TI2 | 3 Audio Outputs
Hello Jeronenl,
Access disabled multi-out for ...
Re: ACCESS VIRUS TI2 | 3 Audio Outputs
Hello FidelityMusic,
Thanks so much for your r...