Hi there,
The curve of an automation clip shows only the percentage value of the selected point:
Could it be possible that the value shows the value of the linked control like it was moved with the mouse:
Or is there already a workaround?
Thanks!
Automation Clip should show value for the automated control
[You can only see part of this thread as you are not logged in to the forums]
Automation Clip should show value for the automated control
You do not have the required permissions to view the files attached to this post.
Re: Automation Clip should show value for the automated cont
I just found out that it would also be great, i...
Re: Automation Clip should show value for the automated cont
This would make automation a hell of a lot easi...
Re: Automation Clip should show value for the automated cont
Paulm12 wrote:The only workaround I know of is ...
Re: Automation Clip should show value for the automated cont
I don't think it's possible. You can link multi...
Re: Automation Clip should show value for the automated cont
Good point regarding the automation clip. Howev...