XY Automation Clips

Post your ideas and suggestions here

Return to “To Do”

[You can only see part of this thread as you are not logged in to the forums]
3Li
Fri Apr 18, 2014 1:30 am

x

XY Automation Clips

It would be useful to have automation clips that controls an xy pad, rather than time being on the x-axis, the clip has a start and end point that can be anywhere on the clip. The time it takes to go from start to end is based on the length of the clip. The clips x and y axis are 1:1 to the controller.

This will make visualizing xy automation easy, especially if automating surround panning.

Return to “To Do”