Creating an automation point on an existing line.

Post your ideas and suggestions here

Return to “To Do”

[You can only see part of this thread as you are not logged in to the forums]
Alphons
Sat Mar 11, 2017 7:20 pm

x

Creating an automation point on an existing line.

Fairly simple. When Clicking on an existing automation point it stays on that height.
That way i can drag it left of right without having to worry about it staying on that height.

Now, if i have a straight line and i want to add an automation point, i would like to see shift click to add it on the line.
Afterwards it should just act the way shift clicking on an existing automation point would.
So far shift clicking doesnt do anything exept creating an automation clip and having the height fixed where it was created.

If i for example want to create a ramp up to a point i would need to copy the amount from another automation point (because type in value is not possible yet on automation point) create the point, paste the value and then drag the first point down.

Possibly make the option toggleable since there might be someone who uses shift click and wouldn't like the fixed hight.






Return to “To Do”