Manufacturer: DJ TechTools
Product page: Here
Supported in FL Studio since: TBA
Setup:
1. Download Midi Fighter Utility.
2. Update firmware (support was designed for firmware of 30 May 3013).
3. Upload (FL Studio)\System\Hardware specific\DJ TechTools Midi Fighter 3D\FL Studio.mfs
4. Enable controller in FL.
Mapping:
stop: hold while pressing pads to stop tracks or press alone to stop all tracks.
scene: triggers vertical columns or grouped clips.
snap: bypass snapping.
(double tap scene or snap to 'lock' them on).
overview: displays an overview of 4x4 zones, press a button to jump to the corresponding zone.
queue: queues the next clip(s).
+scene: triggers vertical columns or grouped clips but adds to the existing triggered clips.
3 pages:
Press to jump to special page, pressing the same page again will go back to the previous page.
keyboard: Notes starting from C5. Use scene to enable Latch mode, stop to end latched notes.
Gross Beat: Link to Gross Beat effect slot selector.
system: Transport and tempo controls.
Poly tilting (toggle):
When OFF:
-Tilting X & Y is global, 2 absolute params, even when you're holding pads.
-Pressing any pad and rotating sends 1 relative param (so you can tweak a knob by rotation).
When ON:
-Tilting X & Y is global if no pad is pressed, or for the pad's track if a pad is held.
-Pressing any pad and rotating sends a relative param for the pad's track.
You can adjust animation, rotation range, tilt dead zone/range/sensivity in the MF3D editor.
Poly tilting links:
Channel 1 = Rotation
Channel 2 = Tilt X
Channel 3 = Tilt Y
Poly tilting off: CC = 0.
Poly tilting on: CC = track #, starting from 1.
DJ TechTools Midi Fighter 3D
Return to “MIDI Controller Reference List”
[You can only see part of this thread as you are not logged in to the forums]
DJ TechTools Midi Fighter 3D
You do not have the required permissions to view the files attached to this post.