Stanton SCS-3D/DaScratch

[jmc]

Manufacturer: http://www.stantondj.com
Productpage: http://www.enterthesystem.com/system/scs3d/
Supported in Deckadance since: 1.40.4

[L.S.D]

Configuration Instructions

(0) Connect the SCS.3d to your computer.

(1) Start DaRouter software and select "GEN Single SCS.3d Dual Virtual V1.00" in the active preset dropdown selector.

(2) Start Deckadance software and enter in the "SETUP" window.

(3) Enable in the midi interface list "INPUT: FROM DAROUTER" (...make sure that it's on) and select the SCS.3d in "REMOTE CONTROLLER DEVICE".

(4) Enjoy. Don't forget to read the explanation of the mapping below.

Global Controls

The center section of DaScratch switches its function based on which mode is selected. Certain buttons never change their function and are referred to “Global Controls”. Global controls are controls whose function doesn't change when the mode is changed. We'll start with the mode switching section…

FX - Sets 3 slider mode EQ - Sets 3 slider mode LOOP - Sets Button mode TRIG - Sets Button mode VINYL - Sets "Circle" mode DECK - Switch the unit from deck A to deck B Below is a list of the global controls. PLAY - Play/Pause CUE - Cue/Stutter SYNC - Sync TAP - Tap tempo of the selected deck

Vinyl Mode

When activated, this mode puts the SCS.3d into “circle mode”.

SLIDERS S1 - Deck Volume S2 - Deck Pitch S4 - Deck Scratch C1 - Deck Pitch Bend Nudge BUTTONS B11 - Jump 1 Beat Backward B12 - Jump 1 Beat Forward B13 - Jump 1 Bar Backward B14 - Jump 1 Bar Forward

Loop Mode

This preset puts the SCS.3d into button mode.

SLIDERS S1 - Deck Volume S2 - Deck Pitch BUTTONS B1 - Deck Loop B2 - Deck Leap B3 - Deck Loop Size Decrement (Half) B4 - Deck Loop Size Increment (Double) B5 - Deck Loop Snap Mode B11 - Loop Move 1 Beat Backward B12 - Loop Move 1 Beat Forward B13 - Loop Move 1 Bar Backward B14 - Loop Move 1 Bar Forward

Trigger Mode

Trigger mode is another button mode preset.

SLIDERS S1 - Deck Volume S2 - Deck Pitch BUTTONS B1 - Jump to Cue Point #1 B2 - Jump to Cue Point #2 B3 - Jump to Cue Point #3 B4 - Jump to Cue Point #4 B5 - N/A (...free for user) B11 - Set Cue Point #1 B12 - Set Cue Point #2 B13 - Set Cue Point #3 B14 - Set Cue Point #4

FX Mode

When activated, FX mode puts the SCS.3d into “3 slider mode”, which turns the control circle into 3 virtual faders.

SLIDERS S1 - Deck Volume S2 - Deck Pitch S3 - FX Depth S4 - FX Select S5 - FX Dry/Wet BUTTONS B11 - Master FX WAH-WAH Filter B12 - Master FX Panoramic LFO B13 - Master FX Ring Modulator B14 - Master FX Track Coder

EQ Mode

This is another 3 slider mode preset.

SLIDERS S1 - Deck Volume S2 - Deck Pitch S3 - Deck Low Eq S4 - Deck Mid Eq S5 - Deck High Eq BUTTONS B11 - Mid Eq Kill B12 - High Eq Kill B13 - Low Eq Kill B14 - Reset Eq sliders