The audio clips and patterns in my project end at all different places.
So, I want to end the song at 3 minutes and 50 seconds but the drum pattern ends at 4:30, an automation clip ends at 4:40, another audio clip at 4:15 etc. I could go through the entire playlist and manually cut every clip, pattern, etc at exactly the same stopping point i.e. 3:50 but I have a lot of tracks and it would be time consuming. (I could try cutting all tracks at once but wonder if that will mess anything up)
I'd like to export the track but I want to cut it at 3:50. Is there something in the Rendering/Export popup menu that would allow me to set a cut off time? I see Length and Total time listed under the Mode and Tail drop down boxes but no way to adjust these.
Thanks
Question about rendering/exporting length of song
Return to “FL Studio Users Forum (Looptalk)”
Forum rules
Please read them here.
Please read them here.
[You can only see part of this thread as you are not logged in to the forums]
Re: Question about rendering/exporting length of song
You could chose to render Song Selection…
ren...
You do not have the required permissions to view the files attached to this post.
Re: Question about rendering/exporting length of song
Hey levendis,
Thanks. Do you mean that I woul...
Re: Question about rendering/exporting length of song
A timeline selection which ends at 3min50sec is...
Re: Question about rendering/exporting length of song
Thanks levendis I'll give it a shot. Much appre...