So, I've been noticing in the "Zone" tab of directwave, that it is a simple matter to adjust parameters per zone using "current selection" as opposed to global. The "edit/automation" note leads me to believe that this applies to both manual setting and automation, however this seems not to be the case (or at least within patcher).
There is only one parameter input for each knob/slider in the zone tab, no matter how many zones are there. This means that the parameter changes for all zones, no matter the setting between "current selection/global."
Is there something I am missing regarding automating these parameters per zone, especially in patcher?
If this is impossible, then I would submit it as a feature request. Per zone editing enhances most directwave patches, and per zone automation would expand it greatly.
Zone automation in DirectWave
Return to “FL Studio Users Forum (Looptalk)”
Forum rules
Please read them here.
Please read them here.
[You can only see part of this thread as you are not logged in to the forums]
Re: Zone automation in DirectWave
If you look at all the automatable parameters i...
Re: Zone automation in DirectWave
Bypherkator wrote:If you look at all the automa...
Re: Zone automation in DirectWave
Spivkurl wrote:
- Have each of the four zones...
Re: Zone automation in DirectWave
I couldn't even figure out how to set different...
Re: Zone automation in DirectWave
ReedIndeed's suggestion is probably the best wo...
Re: Zone automation in DirectWave
Spivkurl wrote:As an example, say I have four z...
Re: Zone automation in DirectWave
nucleon wrote:Spivkurl wrote:As an example, say...
Re: Zone automation in DirectWave
In this case the Mod Val is the source, then yo...
You do not have the required permissions to view the files attached to this post.
Re: Zone automation in DirectWave
nucleon wrote:In this case the Mod Val is the s...
Re: Zone automation in DirectWave
The list and order of parameters Directwave pub...
Re: Zone automation in DirectWave
Very excited to give this a try in the next ses...