Audio is being routed out of FL for external processing. Signal goes through, but there's either immense down-sampling or silence with a few clicks and pops. This affects all of my existing projects and is also valid for any type of audio source (samples, plug-ins etc.)
However, If I open a new project and send the same audio/samples via the same routing, everything works fine.
I hadn't worked on my projects for a while, as I've been moving a lot and could not get my hardware set up for it. I first spotted this issue yesterday with version 20.1.2 [build 877]. Updated today to the latest 20.5 release, but the issue persists.
There's no difference in the settings of the existing projects and those of a new project. I'd worked on these projects with 20.1
With 20.5 the Underruns are stuck to 0 and do not seem to move, whereas with 20.1.2 a different number was shown on every new load of an existing project.
P.S - The screenshots are from my initial post (not that relevant) and I do not know how to remove them.
Discuss how to use FL Studio
12 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]