I want to save time and would love to know if it is possible to link all the existing automations I have on one synth to a new synth. Right now I do it the hard way and link one and one automation (browse parameters - find the parameters I want to automate and then link to controller). Most of the time I use a lot of automations with subtle changes on the same paramterer, so this job is both time-consuming and demotivating.
In other words:
If I make a lead in serum and automate 10 different parameters, and then I want to make a bass in a new instance of serum that follows the exact same pattern - is it possible to just "link all parameters with serum #1" ?
Discuss how to use FL Studio
2 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]
TEFL wrote: ↑Fri Nov 08, 2019 8:55 pm Right now...