How to make a knob inversely follow another

Discuss how to use FL Studio

Return to “FL Studio Users Forum (Looptalk)”

[You can only see part of this thread as you are not logged in to the forums]
LeCroix
Wed Jan 13, 2021 5:19 pm

x

How to make a knob inversely follow another

Sup guys, I'm making a Patcher preset where signal is split in two between a 100% dry signal going straight out and a 100% wet signal going into MicroShift. I want to change the amount of MicroShift in the signal using Fruity Balance's gain knob. However, I also want a Fruity Balance on the 100% dry signal moving inversely so that when I increase the amount of wet signal, my total gain remains unchanged. I know I can make them both follow the same automation, one mapped as Input and one as 1-Input.

Is there a way to make it so it also follows the changes I make manually if there is no automation? If I don't have any automation on Fruity Balance, but I tweak the gain knob, can the other instance of Fruity Balance inversely follow?

Hope that was clear enough. Thanks!

Trancit
Wed Jan 13, 2021 5:35 pm

x

Re: How to make a knob inversely follow another

To my knowledge it isn´t possible to modulate a...



Return to “FL Studio Users Forum (Looptalk)”