Sup guys, I'm making a Patcher preset where signal is split in two between a 100% dry signal going straight out and a 100% wet signal going into MicroShift. I want to change the amount of MicroShift in the signal using Fruity Balance's gain knob. However, I also want a Fruity Balance on the 100% dry signal moving inversely so that when I increase the amount of wet signal, my total gain remains unchanged. I know I can make them both follow the same automation, one mapped as Input and one as 1-Input.
Is there a way to make it so it also follows the changes I make manually if there is no automation? If I don't have any automation on Fruity Balance, but I tweak the gain knob, can the other instance of Fruity Balance inversely follow?
Hope that was clear enough. Thanks!
Discuss how to use FL Studio
3 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]