editing the sensitivity of parameters inside patcher
Return to “FL Studio Users Forum (Looptalk)”
Forum rules
Please read them here.
Please read them here.
[You can only see part of this thread as you are not logged in to the forums]
editing the sensitivity of parameters inside patcher
Say I have a surface knob that controls a lowpass filter. However, I want the filter slope to start at 1k and only go to 10k. Say that this knob also controls the dry/wet mix of a reverb, but I want the full range from 0 - 100% wet. How do I do that? I've connected the knobs to a valhalla room vst plugin and to a fruity parametric eq 2. The knob works fine, except I want the lowpass filter to start moving from a different frequency. I've messed around with the minimum and maximum values setting, but it doesn't work. It always starts at 0 hz. Any ideas?
Re: editing the sensitivity of parameters inside patcher
I can do this outside of patcher. Just use a ma...
Re: editing the sensitivity of parameters inside patcher
I think you might want to use fruity x-y-z cont...
Re: editing the sensitivity of parameters inside patcher
lancelance5_x wrote: ↑Sat Jan 22, 2022 12:49 am...
-
- Technical Support
- Sat Jan 22, 2022 10:21 am
Re: editing the sensitivity of parameters inside patcher
Audiobusters wrote: ↑Sat Jan 22, 2022 5:16 am
l...