Fabfilter pro q3 output level can be controlled only by the volume knob in the channel rack and then you can see its spectrum analyzer increase and decrease, what is very important for mixing. But when I mix a track I like to use only the mixer faders. I keep all the channel rack channels at 100% volume.
However, only the pro q3 output of the master channel can be controlled by sliding the mixer faders of the other channels.
I had a theoretical solution but it actually isnt. Using a control surface knob to link the mixers faders and pro q3 output together. But I need to link them directly. In other words, when I slide the mixer faders I need the pro q3 output to be changed as well.
It would be very helpful. I wonder if others have the same issue.
Exchange FL Studio tips & tricks
1 post • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]