How do I send the signal of the first filter into the second one serially?

find/exchange/discuss Sytrus presets & tips here

Return to “Sytrus - Presets & Programming”

[You can only see part of this thread as you are not logged in to the forums]
BeeFef
Fri Feb 12, 2021 11:48 am

x

How do I send the signal of the first filter into the second one serially?

The "Next" knob in the Sytrus filter section seems to mix one filter with the one I'm "sending" into parallel-ly, so for example if I want to apply a lowpass filter, then apply a high pass filter that tracks with the note to filter out any garbage frequencies below the fundamental (caused by the aliasing from the FM section, despite switching anti-aliasing on for all of the operators), instead of keeping all the high frequencies at the volumes that they were from the first filter, they get added back in because of the signal from the high pass filter. I want both filters on the same signal path, not a signal split with one filter on each side of the split and mixed back together. I could just do that by turning the knobs for multiple filters and outputs up in the matrix. If the parallel-ness of the "Thru" function is intentional can they make a serial mode for the thru knob so it isn't so useless (and do the same with Love Philter)?



Return to “Sytrus - Presets & Programming”