Hi Everyone.
I'm having a problem with DirectWave not detecting the velocities from the filename on imported samples. I have the following round robin kick samples:
KICK_C3_127_1
KICK_C3_127_2
KICK_C3_64_1
KICK_C3_64_2
When I import these samples into DirectWave, the high velocities are set to 127 and the low velocities are set to 0. This is incorrect. I expect DirectWave to map these files according to the the naming convention the files have like so:
KICK_C3_127_1 maps to C3 with velocities from 65 to 127
KICK_C3_127_2 maps to C3 with velocities from 65 to 127
KICK_C3_64_1 maps to C3 with velocities from 0 to 64
KICK_C3_64_2 maps to C3 with velocities from 0 to 64
Am I missing something here? How can I get the velocities to map properly?
Sampling Drums With Round Robin Samples
Return to “Direct Wave - Presets & Programming”
[You can only see part of this thread as you are not logged in to the forums]
Re: Sampling Drums With Round Robin Samples
Have you tried the syntax outlined in the manua...
Re: Sampling Drums With Round Robin Samples
I tried out that naming syntax and I was not ab...
Re: Sampling Drums With Round Robin Samples
I remember that there have been problems with t...
Re: Sampling Drums With Round Robin Samples
The metadata comment is interesting...
Got Went...
You do not have the required permissions to view the files attached to this post.
Re: Sampling Drums With Round Robin Samples
I've periodically tested this feature over the ...