Some controllers send 0xFE every 300ms or so as a 'keep alive' signal.
The issue is that FL seems to treat this as a potential mappable input. So if you click the Multilink knob, it is instantly disabled with the error "You didn't tweak any control"
So this requires using the browser to find parameters and link.
Here is an image of my debug panel with the controller idling:
And here is a gif of the issue in action:
Note the green knob constantly blinking and the error in the Hint panel.
FLStudio mapping does not work properly with Active Sensing sending controllers
Return to “MIDI Controller Support”
[You can only see part of this thread as you are not logged in to the forums]
FLStudio mapping does not work properly with Active Sensing sending controllers
You do not have the required permissions to view the files attached to this post.
Re: FLStudio mapping does not work properly with Active Sensing sending controllers
Have you tried reloading your controller? I don...
Re: FLStudio mapping does not work properly with Active Sensing sending controllers
Interesting, just had a look at this and was no...
You do not have the required permissions to view the files attached to this post.
Re: FLStudio mapping does not work properly with Active Sensing sending controllers
Hi. I am also in trouble in the same state. The...
Re: FLStudio mapping does not work properly with Active Sensing sending controllers
I too am having this issue.
I have a Yamaha P11...
Re: FLStudio mapping does not work properly with Active Sensing sending controllers
Noticing the same thing with a Roland RD800, co...
Re: FLStudio mapping does not work properly with Active Sensing sending controllers
You maybe can stop them on their way in w/midi ...
Re: FLStudio mapping does not work properly with Active Sensing sending controllers
I am having this issue still in 2020.
Does an...