Hey yall!
I'm currently trying to control several instruments inside of FL using Orca to make some pseudo-generative stuff. However some of the instruments that I'm using don't allow me to assign a MIDI channel they will use for note information. Most of the time they'll take any MIDI signal, trying to play everything that is going on in Orca regardless of the MIDI channels I've set. The wrapper only allows me to set a MIDI port which I can't do in Orca. VSTs like Spitfire LABS or NI Kontakt have this setting inside their interface but is there a way to assign these channels outside of the plugin?
(I'm using loopMIDI to route MIDI from Orca to FL if that has anything to do with it. With LABS it actually works that way.)
Question about MIDI routing using Orca
Return to “MIDI Controller Support”
[You can only see part of this thread as you are not logged in to the forums]
Re: Question about MIDI routing using Orca
You can lock channel to rack position. Maybe g...
Re: Question about MIDI routing using Orca
Thanks, didn't know you could set the MIDI chan...
Re: Question about MIDI routing using Orca
Can't know.
Perhaps if you post explicit detail...
Re: Question about MIDI routing using Orca
Okay, I might've found some kind of solution.
A...