I'm reading Synthmaker Instruction Manuel Ch4. (Managing Complexity) pg. -50- where it talk about Inputs and Outputs.
It reads, "To get information into and out of a module you need to add inputs and outputs. To do this, just drag them in from toolbox in the usual way (you'll find them under the Module group)."
When I try to do this, both the Input and Output modules in the toolbox are disabled. Why is that? I can't seem to get around this issue, does it have to do with the sound card settings? I tried to use Synthmaker as an effect and a sound, but still the Modules are disabled. Thank you, much guys any help would be great!
~Also, where is the best place to go to when it comes to specific questions about Synthmaker?
Discuss & exchange FL SynthMaker presets here.
2 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]
Are you drilled down into a module? It doesnt ...