Is there a way to reset pitch slider without clicking on it?

The place to upload Harmless presets and discuss programming it.

Return to “Harmless - Presets & Programming”

[You can only see part of this thread as you are not logged in to the forums]
Thu Mar 07, 2019 2:57 pm

0 x

Is there a way to reset pitch slider without clicking on it?

Hi. I'm enjoying using the master pitch slider as a fun effect, but after I use it, I want to be able to go back to perfect pitch without going into the plugin with my mouse and centering it.

My problem is that the 0-127 CC messages I am able to input to the plugin can't center it on pitch. I used a knob programmed to output a range of 63-64, and neither of those was the true center, and they make the synth out of tune. It seems that the only way to center it in tune is to use the mouse.

Is there any other way to reset the master pitch parameter? Does it accept high resolution midi CC? I don't have any, but I'm looking for a way to generate one.

If I sent a high resolution 0 message to it, would that center it?

I'm using Reaper, so I'm open to hacky solutions. Like I said, sending a 63 or a 64 signal is off pitch, whether I use Reaper's or Harmless's MIDI learn.

Any wisdom? Thanks.

(Another tidbit: using the mouse gives an auto-centering notch, while using a knob does not. It would be great if the plugin treated MIDI knobs the same as the mouse.)

Return to “Harmless - Presets & Programming”