About the preset:
- The patcher must be loaded into the master channel
- Insert channels 1-12 are for audio inputs. The channels must be routed to the master channel (unmuted, volume 0dB). No need to arm the channels in the mixer.
- Insert channels 13-16 are for groups where already recorded audio, synths etc in the project should be routed. The channels must be routed to the master channel (unmuted, volume 0dB)
- Insert channel 17 is for the metronome. The channel must be routed to the master channel (unmuted, volume 0dB). Route the metronome to this insert channel in the audio settings menu.
- All sound should be routed to the patcher via insert channel 1-17 as described above, adjust volume and pan in the patcher dashboard
- Use play/stop in the transport panel in FLS, not in Edison
- Enable/disable rec in patcher dashboard, not in the FLS transportpanel
- Send audio from Edison to playlist when you have a take you want to keep. These will by default be routed to the master channel and must be muted in the playlist if you want to continue recording
- NOTE: Recording duration is by default limited to 20 minutes in Edison which means that audio will be overwritten when this limit is reached. "In new project" is by default enabled in Edison which means that all audio will be deleted if you disable rec and then enable it again in patcher dashboard. Change these settings if required.
- Multitrack 3.JPG (117.24 KiB) Viewed 2530 times
- Multitrack 2.JPG (88.83 KiB) Viewed 2530 times
- Multitrack 1.JPG (226.44 KiB) Viewed 2530 times