NB : not talking about visual smoothing but the parameter smoothing.
where can I turn the parameter smoothing off ? I tryed to tweak the ramp knob in the advanced tab I can reduce the ramps but not eliminate them.
it creates some kind of artefacts/glitches at the beginning of automations (thus implying to start the automations before, which is a constraint and sometimes impossible) and it's impossible to do steppy automations (the ramps ruin the rupture effect).
I hope it's possible, at least for the filters.
The place to upload Harmor presets and discuss programming.
12 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]