Unison index mapping example "Dual-voice mode" don't work?

The place to upload Harmor presets and discuss programming.

Return to “Harmor - Presets & Programming”

[You can only see part of this thread as you are not logged in to the forums]
NBG
Tue Jan 10, 2012 5:05 pm

x

Unison index mapping example "Dual-voice mode" don't work?

From the help file:
Dual-voice mode - With a Unison of 2 (with the Pitch > Unison index mapping setting the second voice set an octave below the first) and the Timbre 1 & 2 mix > Unison index mapping set to play a square wave on voice 2, you now have a Saw with a Square 1 octave below at the same time, with only one part.
For my example i'm using this settings:

Timbre 1 = Sine
Timbre 2 = Square
Timbre Mix = 50%

Unison = 2 Voices
Pan = 0
Pitch = 0

Pitch > Unison index mapping = 0 to 12 (Square should play 1 octave above)
Timbre 1 & 2 mix > Unison index mapping = 0% to 100%

I hear now a mix of a sine and square but something is wrong. If i set the timbre mix to 0% i'm only hearing the sine BUT it is octaved!

What did i wrong?
mapping.fst
Thanks!
You do not have the required permissions to view the files attached to this post.



netwalker
Tue Jan 10, 2012 9:39 pm

x

Re: Unison index mapping example "Dual-voice mode" don't wor

I can't hear any changes, too, the sine has the...
You do not have the required permissions to view the files attached to this post.




Return to “Harmor - Presets & Programming”