I am looking to have the movespeed value be 0.08333325386047 since this represents a semitone in Kilohearts resonator, while also being able to have the minimum value of the knob in Patcher/Control Surface be the lowest key that I'd like to use; ie: A which is equal to 0.574999988079071
Is there a way I can define the movement of Patcher knobs more precisely?
I'm trying to set up a resonator rack that uses Kilohearts Resonator and I'd like to have the knobs move in semitones. Currently I have the math figured out on how far each semitone is from another, but Patcher does not allow anything under 1 to be used for movement speed, making this rather difficult. Is there a way to program the Formula controller to translate this or will Patcher possibly receive an update so that I can define smaller values?
I'll include some screenshots/math below to try and show what I mean. The first is a picture of where the movespeed is located, the second is the speed I input and the third is what Patcher reads it as (where you can see that it did not accept the number I gave it.)
Post your ideas and suggestions here
6 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]