This feature would be a massive timesaver. Yes, it is possible to edit samples in Edison to chop off any leading space, but when you're building kits on the fly during a session, and you find a great sample that needs a trim, it takes you out of the flow of the process to then have to go edit it.
Being able to simply slide the sample start point over a bit right in FPC would be a godsend.
Falls under the category of "dear god please implement this I am dying over here".
Post your ideas and suggestions here
2 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]
found myself in this position many times; other...