Dear Image-Line team,
I would like to be able to save and load multiple mixer channels simultaneously, much in the same way as a saved layer state allows for multiple channels to be loaded in one go. There are multiple use cases for this. For example when loading a layer with multiple channels, you would be able to load the corresponding mixer “layer” state. Or when there’s a particular way you like to mix drums, vocal and guitar layers. I know you can use a template, but that is only at the start of a project, plus it’s stil a lot of work to individually set up the mixer states that I like. Would be a great workflow enhancer/time-saver.
Thank you for reading and hopefully you will take this into consideration.
Post your ideas and suggestions here
1 post • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]