I wish in the “automation/link to controller” (remote control setting), MAPPING FORMULA, I could draw the map diagram.

Post your ideas and suggestions here

Return to “To Do”

[You can only see part of this thread as you are not logged in to the forums]
Milinor
Mon Jul 27, 2020 6:24 pm

x

I wish in the “automation/link to controller” (remote control setting), MAPPING FORMULA, I could draw the map diagram.

in here:
remote.JPG
just like this:
waveshaper.JPG

#38byMilinor
You do not have the required permissions to view the files attached to this post.

Return to “To Do”