Automation Clip Editing - Alt & Geometric angles

Post your ideas and suggestions here

Return to “To Do”

[You can only see part of this thread as you are not logged in to the forums]
billstei
Sat Sep 08, 2007 2:45 pm

x

Automation Clip Editing - Alt & Geometric angles

Currently in Automation clip editing we have:

Hold down Alt, then left-click point = Delete point
Left-click point, then hold down Alt = not assigned ?

Assuming that is the case, how about:

Left-click point, then hold down Alt = snap vertical at same level as previous point

Could also snap to standard geometric angles, aka -90, -60, -45, -30, 0, 30, 45, 60, 90 (not necessarily with straight tension, but maybe) The perfect horizontal is the one that might save CPU a little, or no? Could also color perfect horizontal lines differently so it is easy to check visually.

Bill

Return to “To Do”