At the moment, you can click on a band token and move the mouse along the X axis to set the frequency and along the Y axis to either cut or boost.
But when it's set to Low/High or Band pass modes the Y axis does nothing. In this case the Y axis can be set to bandwidth(resonance).
This can come in handy while recording automations. The cutoff frequency and resonance can be recorded in one go with a single mouse click, much like the autofilter in Ableton. There is a way to do this by linking it to XY or XYZ controllers, but I think this is a feature that should be built into the EQ.
A Suggestion To Make EQ2 Better
[You can only see part of this thread as you are not logged in to the forums]
-
- Technical Support
- Thu Jun 10, 2021 12:26 pm
Re: A Suggestion To Make EQ2 Better
I personally prefer mouse scroll does change BW...
Re: A Suggestion To Make EQ2 Better
Milinor wrote:
I personally prefer mouse scroll...
You do not have the required permissions to view the files attached to this post.