The right shift cut, in my opinion, is severely marred by the clone-drag action. Clone drag is already in the left-shift, so the action is redundant anyway.
The vertical cut marker in the right shift cut ( as opposed to the normal cut tool's angular marker) is extremely useful in the paint and pencil tools, but it cannot be initiated over a clip, which is inconvenient.
Right now, to achieve the same as the vertical cut, but without the annoyance of the clone-drag in the left shift, we must switch to the cut tool, THEN use right shift.
If the duplicate clip action was limited to left-shift, the problem would be alleviated, and we would have the best of both worlds.
Post your ideas and suggestions here
2 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]