I would like to create a custom script for the Hercules P32, more or less like the one that is made for Ableton. See the link below:
https://remotify.io/product/kuala-hercu ... dj-ableton
I think a nice starting point would be to be able to control performance mode with LED feedback as done ie. with the Launchpad, but also wonders if it would be possible to use it program drums with FPC like this https://www.youtube.com/watch?v=OpToNmn1mKs
Perhaps some of you can point me in the right direction how to start?
I got the following to work:
The controller contains pads, which result into midi notes, and sliders and faders are coming in to FL so as CC's. Also I can set up a MIDI Out and send notes back to the P32 using using the HEX note numbers I have borrowed from http://forum.mixvibes.com/viewtopic.php?f=401&t=38669 but only after I have done some a small conversion. The hex notes are:
Code: Select all
PAD#
13 14 15 16
9 10 11 12
5 6 7 8
1 2 3 4
---------------
CUE Mode
60 61 62 63
5c 5d 5e 5f
58 59 5a 5b
54 55 56 57
-------------
Loop Mode
50 51 52 53
4c 4d 4e 4f
48 49 4a 4b
44 45 46 47
-------------
Slicer Mode
40 41 42 43
3c 3d 3e 3f
38 39 3a 3b
34 35 36 37
-------------
Sampler Mode
30 31 32 33
2c 2d 2e 2f
28 29 2a 2b
24 25 26 27
-------------
Mixer Channel 1
Channel 4
DECK A Channel 2
Channel 5
DECK B Channel 3
Channel 6
-------------------
REC** Channel 1
REC** Channel 4
-------------
SLIP** Channel 1
SLIP** Channel 4
Code: Select all
LED_OFF = 0
RED_FULL = 125
RED_HALF = 21
RED_LOW = 11
BLUE_FULL = 126
BLUE_HALF = 61
BLUE_LOW = 41
PURPLE_FULL = 127
PURPLE_HALF = 101
PURPLE_LOW = 81
Voilla this works.
Now my question is: where to go from here? I have been looking at the hardware specific templates in the system folder to see if I can alter them, but that does not make any sense to me straight away. I there any documentation on this I have missed?