Workaround for PDC in FLStudio 20

Technical support has moved to Ticketing - https://support.image-line.com/redirect ... calSupport

Return to “Technical Support (Windows)”

Forum rules
TECHNICAL SUPPORT HAS MOVED!

Technical support has moved to ticketing - START HERE

Some self-help links ...


NOTE: Technical Support is ONLY available Monday - Friday (9 am to 5 pm), it can take a few days to get a response depending on the level of demand. Thank you for your patience.
[You can only see part of this thread as you are not logged in to the forums]
мя.ωοηδяομs
Fri May 11, 2018 1:07 pm

x

Workaround for PDC in FLStudio 20

So today I tried again.

Reflex said it goes and @ this point I can vindicate, but this work around is very hardcore and this is only a simple Test.

Host Bufferlength 512smp / 12ms
Playback Driver = Driver (Mixer is not accurate enough for MIDI timing)

PDCMixerStateII.png

SamplerKick run true channel 14 with 7 UAD plugs
Channel 1 is the Metronome without any plugs

When we diasable Automatic and remove all PDC values, then both tracks are out of sync
When we enable now Automatic, also both tracks are out of sync
(@This point we can fix them with PDC value 91.43ms @ the Inputlatency from Metronome)


This came from the UAD plugs, automatic PDC will @ this point set in 3 channels TI (185.76ms), Kick (91.43ms) & Overbridge (212.15ms)
When we disable the plugs in Channel 14 then they will in Sync (Metronome&Kick)
(But only when we remove 91.43ms value that we added in the Metronme channel)

So we remove the value from the Metronome channel
Now we look what the MidiOut Channel says, the Audio routed back into the Mixerchannel 15
So we have around 45ms difference delayed to the metronome, also when we enable the plugs in Kickchannel (here we need a higher playback offset -200%/29ms are not enough in this case, dont konw from where the delay came, I tried different midi devices)

Now I tried to come in Sync with the metronome
1st I tried in Channel 15 Input latency +45ms, this take no effect @ this point (@ +1000ms only the grafic output of the Levelmeters (metronome) will delayed by 1000ms)
2nd now -45ms this will move away from sync so we now @91.43ms (@ -1000ms all Levelmeters will be delayed by 1000ms and also the MIDIsound)

Same can we do this again @ the track latency
1st is identical
2nd is also indetical (@ 1000ms the Meters shown correctly with an minimum start delay, but in correct order and time)



We have tested that we come only in real sync with the "playback offset" in audiosettings!


OK, back on track Kick & Metronome are synced with the options above
That means that only TI&Overbridge will have an Automatic PDC entry

Now switch on Audio from TI and we are not in sync, with an delay from 91.xx ms
The Inputlatency on channel 12 will do nothing (audio related) with an positive entry & a negative entry will increase the delay more (here are also the grafics delayed,see description above)
To come with the metronome in Sync we have to add -91ms to the Tracklatency of the metronome, in this case the Drum will dropped out of sync or right descripted, the TI&Metronome will be delayed to the Drum by 91ms, this can be avoided to add an Inputlatency (91.xxms) to the Drumchannel (plugs are deactivated, you know)

OK It,s in SYNC now, 2 values from Automatic & 2 values added manual

So we want to hear what the next plugin do, so we switch on the OverBridge and it's out of Sync
The Inputlatency do that, what we described above, but we come not in sync, we need 110ms to come in SYNC
So we set Metronome track latency to -203 & the Kick latency to 203ms, that we come in SYNC

Here can we also activate our plugins in the Kickchannel and have to set the 203ms to 112ms

So @ this point the TI is again out of SYNC, that can we fix with an Inputlatency from -55ms in the TI Channel
So now the MIDIplug are out of SYNC again, the metronome is delayed by 155ms


@ this point my inclination is going & I dind't want to spend more time with the new PDC functions.
Reflex I will help you where I can, so write some sentence to me ...
You do not have the required permissions to view the files attached to this post.
Last edited by мя.ωοηδяομs on Fri May 11, 2018 1:26 pm, edited 1 time in total.

мя.ωοηδяομs
Fri May 11, 2018 1:19 pm

x

Re: Workaround for PDC in FLStudio 20

reflex wrote:мя.ωοηδяομs wrote:-If I want to tw...

reflex
Site Admin
Mon May 14, 2018 9:50 am

x

Re: Workaround for PDC in FLStudio 20

I'm going to read this in detail in a bit, but ...

reflex
Site Admin
Mon May 14, 2018 1:55 pm

x

Re: Workaround for PDC in FLStudio 20

мя.ωοηδяομs wrote:MIDIOut for an external synth...

мя.ωοηδяομs
Sat May 19, 2018 2:41 pm

x

Re: Workaround for PDC in FLStudio 20

reflex wrote:What is the latency of each of the...
You do not have the required permissions to view the files attached to this post.


reflex
Site Admin
Wed May 23, 2018 3:50 pm

x

Re: Workaround for PDC in FLStudio 20

Does it work better if you set an output on the...

reflex
Site Admin
Thu May 24, 2018 8:12 am

x

Re: Workaround for PDC in FLStudio 20

Looking at the flp, some questions: 1. what is ...



Scott
Site Admin
Sun May 27, 2018 7:15 am

x

Re: Workaround for PDC in FLStudio 20

мя.ωοηδяομs wrote:With the same project, where ...

мя.ωοηδяομs
Mon May 28, 2018 3:22 am

x

Re: Workaround for PDC in FLStudio 20

Mixer Mode is unstable, because Miditiming isn'...
Last edited by мя.ωοηδяομs on Tue May 29, 2018 5:06 pm, edited 1 time in total.

Scott
Site Admin
Tue May 29, 2018 4:24 am

x

Re: Workaround for PDC in FLStudio 20

If you are using external synth hardware, the s...


Jeronenl
Tue May 29, 2018 7:34 pm

x

Re: Workaround for PDC in FLStudio 20

I have big Latency problems too with the Virus ...
You do not have the required permissions to view the files attached to this post.

Jeronenl
Thu May 31, 2018 9:44 pm

x

Re: Workaround for PDC in FLStudio 20

Is there somebody who can help? Maybe sombody ...


doctea
Sun Jun 03, 2018 5:25 pm

x

Re: Workaround for PDC in FLStudio 20

I'm also having problems with compensating for ...

Jeronenl
Sun Jun 03, 2018 6:23 pm

x

Re: Workaround for PDC in FLStudio 20

Yes Doctea, same problems here, indeed very fru...
You do not have the required permissions to view the files attached to this post.

Scott
Site Admin
Mon Jun 04, 2018 12:22 am

x

Re: Workaround for PDC in FLStudio 20

Can't you fix this with the Plugin Latency Cont...

Jeronenl
Wed Jun 06, 2018 10:04 am

x

Re: Workaround for PDC in FLStudio 20

I have got it working!!! I use the Asio driver...


reflex
Site Admin
Thu Jun 07, 2018 7:05 am

x

Re: Workaround for PDC in FLStudio 20

мя.ωοηδяομs wrote:No because, there is an repor...


reflex
Site Admin
Tue Jun 12, 2018 7:43 am

x

Re: Workaround for PDC in FLStudio 20

The metronome is still on the todo list, I'm no...


Dawnchaser
Wed Jun 27, 2018 11:16 am

x

Re: Workaround for PDC in FLStudio 20

Just chiming in here - I too am having an issue...
You do not have the required permissions to view the files attached to this post.




Alphons
Fri Sep 21, 2018 2:37 am

x

Re: Workaround for PDC in FLStudio 20

Not at this point in time. We are however in th...

reflex
Site Admin
Thu Feb 28, 2019 2:09 pm

x

Re: Workaround for PDC in FLStudio 20

мя.ωοηδяομs wrote:PS: with update 20.0.3 the UA...

мя.ωοηδяομs
Sat Mar 02, 2019 2:41 pm

x

Re: Workaround for PDC in FLStudio 20

reflex wrote:мя.ωοηδяομs wrote:PS: with update ...
Last edited by мя.ωοηδяομs on Sun Mar 24, 2019 4:39 pm, edited 1 time in total.

мя.ωοηδяομs
Sun Mar 24, 2019 4:38 pm

x

Re: Workaround for PDC in FLStudio 20

reflex wrote:мя.ωοηδяομs wrote:PS: with update ...

reflex
Site Admin
Mon Mar 25, 2019 6:50 am

x

Re: Workaround for PDC in FLStudio 20

мя.ωοηδяομs wrote:2nd ~ APDC will not work in r...

мя.ωοηδяομs
Tue Mar 26, 2019 6:42 pm

x

Re: Workaround for PDC in FLStudio 20

reflex wrote:мя.ωοηδяομs wrote:2nd ~ APDC will ...

Alphons
Thu Mar 28, 2019 11:12 am

x

Re: Workaround for PDC in FLStudio 20

Could you send us a stripped down template that...



мя.ωοηδяομs
Sun Apr 07, 2019 8:49 am

x

Re: Workaround for PDC in FLStudio 20

Very simple test object, but it's strange also ...
You do not have the required permissions to view the files attached to this post.


mikegonsolin
Tue Jun 25, 2019 3:49 am

x

Re: Workaround for PDC in FLStudio 20

Has there been any fix to this guys? I'm runnin...

Alphons
Wed Jun 26, 2019 2:50 am

x

Re: Workaround for PDC in FLStudio 20

I assume this is an issue related only to UAD p...

mikegonsolin
Wed Jun 26, 2019 4:43 am

x

Re: Workaround for PDC in FLStudio 20

Hey, for me, it was actually an issue related t...



Return to “Technical Support (Windows)”