On every mixer channel there is a Low Shelf, Peak and High Shelf EQ. They are great for a quick rough mix EQ.
It would be even greater and more practical for use if we had a toggle for changing between Low Shelf / Low Cut
or High Shelf / High Cut. This would save a lot of time and I imaging would also save processing power not having to load Parametric EQ into every channel to only make use of Low/High Cut.
Post your ideas and suggestions here
5 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]
There's an EQ there?!
I have asked about this nearly two years ago an...
Yes, good idea, but this EQ is post effects (I ...
A pre/post switch for this would rock. I agre...