I have a KeyLab 61 mkII keyboard and I want to use its sliders and knobs to control the Mixer tracks. With DAW mode set to MCU on the KeyLab, I am able to use these controllers for the first 8 tracks of the Mixer (for volume and panning), which is great.
1) Is it possible to have a setup where I can decide one slider and one knob to control any selected/highlighted Mixer track?
2) In DAW mode only the first 8 tracks can be controlled irrespective on the Mixer track selected. Is it possible to control any continuous 8 tracks instead? I think it might be limited by MCU protocol handling and would not be possible, but if possible, it would be best.
Obviously, I only want this with Mixer focused.
Any help is appreciated. Thank you!
Discuss how to use FL Studio
6 posts • Page 1 of 1
[You can only see part of this thread as you are not logged in to the forums]
Last edited by Kaitav on Wed Mar 25, 2020 10:48 am, edited 1 time in total.
AFAIK - no will need a set of sliders that has ...
HeathW wrote: ↑Wed Mar 25, 2020 10:32 am AFAIK ...
FL Studio Mixer control with KeyLab MKII.mp4
You do not have the required permissions to view the files attached to this post.
Kaitav wrote: ↑Wed Mar 25, 2020 10:47 am With D...
HeathW wrote: ↑Wed Mar 25, 2020 11:59 am Kaitav...